WE ONLY WORK ON THE MACHINES WE SELL

Spring AB-12043.84 

AB-10148.58 

 037.38.001.00.00 CAGE 

JD JET KIT

 SEAT COCEPTS STANDARD SEAT  SKID PLATE 

 BARK BUSTERS AB-11167 

6/22/26 DECK BELT

6/22/26 PTO CLUTCH FALLING OFF, LEFT REAR TIRE GOING DOWN. DECK VIBRATION 

6/22/26 READY TO GO HOME

6/21/26 WASHED THE BIKE REPLACED THE FOULED PLUGS, TESTED THE STATOR 4 DIFFERENT WAYS, ALL TEST WERE IN SPEC. CHARGING THE BATTERY, WILL TEST THE BATTERY WHEN IT'S CHARGED TOMORROW MORNING. 

REPLACE MISSING PIN, 

WONT RUN 

READY TO GO HOME!

6/19/26 MY SON FIXED THE PULLER WITH A MUCH STRONGER BOLT BUT THE HUB STILL WONT COME OFF, I WILL HAVE TO BREAK THE HUB TO REMOVE, I HAVE A NEW HUB ORDERED FROM BOTH HYDRO GEAR (BACK ORDERED) AND FROM BAD BOY . (BAD BOY DOESN'T SHOW ME IF THEY HAVE IT OR NOT) IN THE MEANTIME THE MOWER CAN BE USED UNTIL I GET THE HUB IN. WE JUST NEED TO WATCH THE OIL LEVEL.
6/18/26 I FOUND A BOLT AT TSC , MY SON WILL COME BY THIS WEEKEND AND WELD IT FOR ME TO FIX THE PULLER. 

6/17/28 GOT HERE AT 6 AM HEATED HUB, SPRAYED PB BLASTER AND THE THREADS PULLED RIGHT OUT OF THE PULLER. BACK TO THE DRAWING BOARD. 

6/16/26 SOAKING HUB WITH PB BLASTER OVERNIGHT. 

AXLE SEAL LEAKING 

6/23/26 IDLER PULLEY ORDERED 

1. (ADJUSTED PARKING BRAKE) 

2. HYDRO LEAK ( LINES SEEM TO BE LEAKING AT THE PUMP, I CLEANED AND TIGHTENED ALL OF THEM. I ALSO ADDED DIE TO THE OIL. IF THEY LEAK ANY MORE I WILL BE ABLE TO SEE WHERE

6/23/26 HYDRO CAME TODAY, I WILL GET TO IT ASAP 

6/23/26 BOLTS REMOVED, THREADS REPAIRED, WILL  RE-INSTALL THE ENGINE TODAY AND FINISH THE ANNUAL SERVICE. 

6/19/26 ALSO DO ANNUAL SERVICE 

6/19/26 WELDER WONT DO IT BECAUSE IT'S AND ALUM BLOCK HE CAN'T GROUND PROPERLY. I JUST ORDERED NEW TOOLS TO TRY TO GET THE BROCKEN EXTRACTOR OUT. 

CARBIDE BUR SET AND DIAMOND TIP HOLE SAW SET. 

6/18/26 I WENT TO HOME DEPOT THIS MORNING BEFORE WE OPENED AND PURCHASED COBALT DRILL BIT, IT MADE NO IMPACT AT ALL. I HAVE A WELDER COMING THIS WEEKEND TO SEE IF HE CAN GET DOWN IN THERE AND BUILD IT UP ENOUGH TO WELD A  NUT TO IT AND REMOVE IT. 

6/17/26  6:30 AM NEW EXTRACTOR BROKE IN LAST BROCKEN BOLT. I HAVE TO PURCHASE A DRILL BIT THAT WILL DRILL INTO THE EXTRACTOR. WONT BE DONE TODAY. 

11:54  6 RUINED DRIL BITS AND 3 RUINED EXTRACTORS AND STIL NO MOVEMENT. I HAVE TO GO  AND BUYING MORE DRILL BITS AND EXTRACTORS TONIGHT AFTER DELIVERIES. 

6/21/26 READY TO GO HOME!